More Details

Frame
* Rigid frame
* Epoxy coated steel
* The plastic body work is available in a red colour only
* Features a suspension system which enables the wheelchair to travel up small steps up to 25mm in height

Seat
* Power elevating seat (10 cm rise)
* Foam padded, grey vinyl upholstered seat
* The seat has a lever located under the right hand side of the seat to operate a 360 degree swivel mechanism (which can be locked every 90 degrees)
* Available in one depth and width only

Upholstery
* Foam padded
* Grey vinyl

Backrest
* Foam padded and black vinyl upholstered backrest
* The backrest can also be folded flat onto the seat to facilitate transport

Headrest
* Foam padded and black vinyl upholstered
* Height adjustable

Armrests
* Full length
* Padded
* Removable and flip-up
* Armrest are height, width and angle adjustable

Footplates
* Plastic
* Single piece
* Flip-up
* Height and depth adjustable

Wheels
* 250mm diameter solid tyres

Castors
* Front and rear castors are 150mm diameter solid tyres
* Articulating rear castor beam

Brakes
This power chair is equipped with two brake systems:
* Regenerative - uses electricity to rapidly slow the power wheelchair down when the joystick returns to the center/stop position
* Disc Park Brake - activates mechanically after regenerative braking slows the power wheelchair to a near stop, or when the power is removed from the system for any reason

Controls
* Joystick can be installed on either side
* Joystick (remote plus controller) control direction and speed
* Battery charge monitor on joystick
* Keypad - on/off key, speed settings indicator, horn key
* 40 amp, PG GC 3 controller

Batteries
* 2 x 12 volt deep-cycle
* Battery size: (U-1) 30-34 AH

Motor
* Two-motor, mid-wheel drive
* Motor disengagement is achieved by moving two small levers located next to the rear wheels on the base of the wheelchair

Considerations

Caution: Load Capacity for Powered Wheelchairs
The load capacity of a powered wheelchair may change according to the type of ground the wheelchair is used on. The supplier stated load capacity may have been given for a powered wheelchair that has been tested on flat ground. However, the powered wheelchair's load capacity, performance and stability may change when the powered wheelchair is used on an incline. These factors, including the maximum gradient on which a powered wheelchair should be safely used, should be discussed with the supplier.

Transport Accessibility
The space allowed on public transport for carrying mobility equipment is an area of 1300mm by 800mm.

Wheelchair spaces
All new Sydney buses feature special 'kneeling suspension' and a ramp to provide easy access for less mobile passengers.

There are spaces for two wheelchairs on the new buses. These will accommodate most manual and electric wheelchairs with maximum length 1250mm, maximum width 750mm, maximum turning circle1500mm and maximum weight 200kg.

For safety reasons, passengers in wheelchairs are advised to face the back of the bus, bracing their wheelchair against the side of the space, applying the brakes and securing the seat belt of the wheelchair.

Wheelchair accessible buses display a blue and white wheelchair sign on the front of the bus, and on the easy access door.

Transport Requirements
Occupied Wheelchair in a Car
A person sitting in a wheelchair within a car or van requires certification and RMS (Roads and Maritime Services) approval for the wheelchair and occupants restraint system where the wheelchair or occupant are restrained to the vehicle structure. RMS approval is not required for a postural support, such as a harness, that is only attached to the wheelchair and not to the vehicle.

Wheelchair Restraints
When transporting a person in a wheelchair in a car or van, both the occupant and the wheelchair require a Roads and Maritime Services (RMS) approved restraint system. The wheelchair and the occupant need to be separately secured to the vehicle itself.
RMS approval is not required for a postural support, such as a harness that supports the user in the wheelchair but is not part of the vehicle restraint system.
The use of a headrest is not legally required but strongly recommended. Easily detachable, folding headrests which fit a wheelchair with standard push handles are available. Contact the supplier or refer to section Wheelchair, Scooter, Cushions, ramps / Postural Supports - Seating System: Restraint+Head+Back+Seats

Place Of Manufacture

Pride Mobility Products Corp, USA

Price Guide

Refer to www.pridemobility.com.au for list of suppliers

Models

Multiple models available (see separate items):
* Jazzy Select Elite
* Jazzy Select
* Jazzy Select 6
* Jazzy Select 6 With PES
* Jazzy 1450
* Jazzy Select Elite HD
* Jazzy 623
* Jazzy Air

Options

* Cup holder
* Rear basket
* Oxygen tank holder
* Cane/crutch holder
* Walker holder

Additional Dimensions

Maximum speed ................................................................................... Up to 6.8 km/h
Per-charge range .................................................................................. Up to 20.8 km (Range and speed vary with user weight, terrain type, battery charge, battery condition and tyre pressure. This specification can be subject to a variance of (+ 10% or - 5%)
Overall length ............................................................... 900 mm without front riggings
Battery weight ............................................................................................. 10 kg each
Base weight ...................................................................................................... 46.5 kg
Standard seat weight ...................................................................... 19 kg (high-back)

Maintenance

All wheelchairs require regular maintenance. Refer to User Manual for specific details.

Standards

Standards
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For more information about standards also see
http://at-aust.org/home/assistive_technology/standards.html

TGA
Many of the items on the Assistive Technology Australia website are categorised as a Medical Device. Medical devices that are approved for use in Australia have been entered into a national database called the Australian Register of Therapeutic Goods (ARTG), which is maintained by the Therapeutic Goods Administration (TGA). You can ask the supplier for the ARTG number for the device you wish to purchase and search the ARTG for the entry. To access information on the ARTG visit www.tga.gov.au

When buying a medical device it is advisable to only choose a medical device that is recommended by a healthcare professional and has been included on the ARTG.

Licence & Insurance Requirements

In NSW, motorised wheelchairs that weigh less than 110 kg and cannot travel at more than 10 km/h do not have to be registered, provided they are being used by a person with mobility problems. A person driving a motorised wheelchair under these circumstances is defined as a pedestrian under the Australian Road Rules and is permitted to travel on a footpath or nature strip adjacent to the road.

Vehicles exempt from registration are covered by the nominal defendant scheme (administered by the State Insurance Regulatory Authority) if they are at fault in an accident in NSW on a road or road-related area and cause injury to another person. However, this cover is only valid in NSW.